This two part liquid epoxy system can be used as a one-coat stand-alone protective coating, isolating the metal substrate from the detrimental effects of electrolysis.  An environmentally friendly,100% solids coating that contains no VOC’s, (volatile organic compounds).

 TC^® 7025 EZ FLOW EPOXY provides a thickness up to 25 mils providing a tough resistant barrier when exposed to backfill and soil stress.   EZ FLOW EPOXY provides an EZ alternative to the complex and lengthy application process of field-applied powder epoxy coatings.  

Please click here for TC 7025 PDF Product Sheet.

Use effective cleaning procedures remove all contaminants that would impede bond, too include moisture, salts, grease and any loose material. This may include the use of high pressure fresh water cleaning, using suitable solvents or detergents.  

The surface must have a 2.5 to 4 mil surface profile. This can best be accomplished using a  SSPC-SP-6 abrasive blast or better.

Application

Environment: Use only where application and curing can proceed at temperatures above 40°F (4°C). The temperature of the surface and that of the coating itself must also be within these perimeters.  Apply only on a dry and clean surface with a temperature above the dew point to avoid condensation. Relative humidity maximum is 90% preferably between 40-60%.

 Mixing: Mix the entire contents of the hardener into the resin container and mix thoroughly until thoroughly mixed (approx. 2-3 minutes).
Application Method: Apply epoxy by pad, brush or roller. TC 7025 is also available in a spray grade.

See detailed field specifications for complete instructions.